working on the fenders on the Vicky

I'm starting on the repairs on the fenders for the Vicky. First thing I'm doing is bolting everything together. Then I can check how everything is fitting and see what issues need to be fixed.

I noticed some bondo in the drivers fender hiding some dents. So I removed the bondo and smoothed the dents out.

got the body back on the frame for the Vicky.

I finished up all the repairs on the floor of the Vicky. So I got it back mounted on the chassis in preparation for repairing the fenders.

repaired the rear section of floor on the Vicky.

I had a section of the rest floor that was rusted through. So I found another year floor and used it for my patch panel. Got the bad section removed and welded in the new patch.

Finished repairing the bottom sections of the Vicky.

I finished up repairing the section around the wheel well. This side is all finished. Now there are a couple of areas on the floor that need work.

Finished the patches on the quarter panel on the Vicky.

I finished installing the quarter panel patch and the rocker panel today. I just have a few more things to patch on the floor and the bottom of the car will be done.

repaired the bottom of the cowl on the Vicky.

I finished repairing the bottom of the cowl. And started repairing the bottoms of the sub rails. Once they are repaired then I can start repairing the bottom of the quarter panel.

Finished building the passenger rocker panel on the Vicky.

I finished making the rocker panel for the passenger side. Now I'll be rebuilding the sub rails.

Repaired the bottom of the inner door on the Vicky.

I finished making the patch panel to repair the lower part of the inner door. Got it welded and finished, now I'm grafting the rest of the panel back in.